Updating iBubble

If you cannot synchronize your drone’s remote, and iBubble flashes its green and blue LEDs alternatively, it means that the iBubble remote needs to be activated and updated.

To update your remote, please follow these steps:

1. Make sure that the drone and the remote are turned off.
2. Put the fully charged battery in the drone.
3. Turn on the iBubble remote and place it in the spot at the top of the drone. Do not remove it until the update process is complete.
4. iBubble turns on and begins the update process. It may take up to 10 minutes.
5. Once the update process is complete, the drone and the remote synchronise. At the end, the remote displays “Disarmed Ready”.

During the update process of iBubble, the firmware may get stuck because of a temporary connection loss. If this happens, the progress bar stops moving and the udpate gets stuck.

If this happens, turn off your remote, then put it on iBubble to shut it down. The app will display an error message. Turn the remote back on, then turn iBubble back on and resume the update process via the app.

In order to update iBubble, use the official iBubble Camera available on the AppStore© and PlayStore© and follow the instructions carefully. You can use the user guide available here as a support on the process.
If you are not able to update the drone, please contact our technical support by email support@notiloplus.com.
Please keep in mind that unless a critical update is needed, you will be able to dive with iBubble without updating it.

If the iBubble Camera application doesn’t detect your iBubble, please verify the following point.

• You are trying to connect right after having turned on the drone
• The drone’s remote is still on its dedicated spot on the drone
• You are trying to connect to the right drone’s WiFi starting like ibubble-B827EBXXXX
• You have activated your mobile WiFi and deactivated your mobile data

If the problem appears during the first starting up and update of the drone it can be normal. Indeed, when you send the update from the application to the drone, the drone will restart and update itself and the remote. It can take up to 10 minutes and during this process the drone is not emitting any WiFi signal.

If the problem persists, please contact our technical support by email support@notiloplus.com.

For the first starting up, iBubble will need to be updated and registered.

To do so, please follow these steps:

1. Charge the drone’s remote and battery to the fullest.
2. Download the “iBubble Camera” App on AppStore© or PlayStore© and register your drone following the App instructions.
3. The App will then ask you to download the update needed to set up the drone.
4. Put the 100% charged battery in the dedicated compartment under the drone (a sound signal will inform you the battery is correctly positioned) then close it properly until touch.
5. Switch on the remote by pressing few seconds the “Select” button at the top of the remote and put it on the dedicated support on the drone. Don’t remove it until the end of the setting up process.
6. The drone will turn on and emit a WiFi signal like “ibubble-B827EBXXXXX”.
7. Switch off your mobile data and connect to the drone’s WiFi in order to allow the App to send the update to the drone.
8. Once the update is done, the drone will restart automatically in order to finish the installation and synchronize with the remote. It can take up to 10 minutes.
9. At the end the remote will indicate “Disarmed ready”.
10. You can now set up your preferences on the drone with the App and start to use it for dive or explore (if you have bought the Explorer Pack).

Do not hesitate to check our videos tutorials here.

To calibrate the drone, put it on a flat surface, connect it to the iBubble Application and launch the calibration process via the app.